Safety Operating Regulations for Industrial Gas Burners
1、 Starting operation of gas burner:
1. For newly installed gas burner bodies, it is necessary to carefully test whether the gas meets the requirements of the burner before debugging; Check whether the testing instruments on the gas supply pipeline are normal, whether the pipeline valves are opened and closed normally, and whether it is convenient for future use and maintenance.
2. For newly installed pipelines, carefully check the installation reliability and sealing of all pipelines.
3. Users of separate gasification stations should ensure that the gas supply volume and parameters meet the requirements for safe combustion.
4. Operators should carefully read the operating manual and master the knowledge and methods of safe operation.
5. Before starting each time, check if the gas valve is open, otherwise the burner will not work.
6. Press the button to activate the power control on the control cabinet. At this point, the digital display table will display the current furnace temperature, which is the ambient temperature of the newly installed furnace.
7. Start the fan control button, and the fan installed on the furnace body will work. If the fan damages the control cabinet, it will automatically protect it from the next step.
8. When there are no abnormalities in the operation of the combustion fan, restart the combustion control button. At this point, the combustion program controller begins to operate.
When the combustion controller receives signals that are not conducive to combustion (such as ignition failure, unstable air pressure, circuit problems, etc.), the combustion controller will immediately shut down the gas and issue an alarm signal.
If the combustion controller alarms, it must be manually reset by the operator after the fault is resolved before continuing to operate.
11. For the operation of the entire equipment, operators should refer to the furnace safety operating procedures and production process requirements for operation.
12. Adjust the control temperature according to the production process needs, and operators should refer to the intelligent CNC workbench for manual adjustment.
2、 Operation of gas burners:
There are two modes of shutdown: automatic shutdown when the temperature in the furnace reaches the set value. At this point, the operator does not need to operate anything. When the temperature inside the furnace falls below the set value, the controller will automatically start.
2. In the case of manual shutdown and shift shutdown, the operator should start the machine in reverse order (1. First turn off the combustion control button; 2. Then turn off the fan button; 3. Finally turn off the power and press the button;)
If the shutdown time is long, the operator should close the gas pipeline valve to avoid gas leakage.